Sporathe knowledge network
ES
Universidad Nacional de Colombia

Medellín - Ciencias Agrarias - Doctorado en Ciencias Agrarias · 2021

Characterization of the wood Pinus oocarpa Schiede ex Schltdl.var.ochoterenai as structural raw material

The wood obtained from fast-growing plantations is an effective substitute for wood from natural forests, thus helping in reducing the pressure on these ecosystems. However, this wood presents problems of low dimensional stability and low physical and mechanical properties which limits its use as structural raw material. This doctoral thesis presents the changes in the properties of modified wood as a result of using polymer impregnation and the effect of heat treatment on Pinus oocarpa wood from forest plantation origin. The wood samples were impregnated in hot bath at 95 °C, and then impregnated at room temperature; the effects were evaluated related to the results of density, dimensional stability, bending strength and compression parallel to the grain, the assessment of the wood was carried out under the Colombian Technical Standards NTC 290, 663, 784. The effects of heat treatments at 170 °C and 190 °C for 2.5 hours in saturated vapor were evaluated based on their color, dimensional stability, air-dry and basic densities, modulus of elasticity (MOE), and modulus of rupture (MOR) in static bending. The evaluations were carried out following the Colombian Technical Standards NTC 290 and 663, and the color changes resulting from heat treatments were monitored using the CIE-Lab. In addition, changes caused by the thermal modification on the chemical composition and microstructure of wood were evaluated. The evaluation of chemical changes was performed following the Tappi standards and Fourier Transform Infrared Spectroscopy (FTIR), and the wood microstructure was characterized by optical microscopy. With the modification of polymer impregnation, the density increased, the anti-swelling efficiency was 60%; the modulus of rupture in static flexion increased 20%, modulus of elasticity 39% and compression parallel to the grain increased 8%. For the effect of thermal modification treatment there was a low mass loss. The air-dry and basic densities were higher in 170 °C treatment and increased the dimensional stability of the treated wood; after treatment, the general color change (∆E*) increased gradually with the increase in the treatment temperature, resulting in a high color change to a very different color; the bending strength of thermally modified wood was improved and significantly increased to values higher than those of unmodified wood. In the evaluation of chemical changes, the results showed a decrease in holocellulose content and the lignin content and extractives increased. C-O groups were degraded and -CH3 groups (lignin) were increased during thermal modification. Thickness of the tracheid walls decreased in earlywood and in latewood; lumen diameters increased in earlywood and in latewood. Impregnation with polymers evidenced wood with greater dimensional stability and better physical and mechanical properties. The high densities, improved dimensional stability and resistance to bending, and attractive appearance of the treated wood indicate that the modifications applied are a promising alternative for the transformation of Pinus oocarpa wood into a raw material with a high added value.

Full text 90 pages with text out of 99

Read the full thesis Record in the repository

Contents

Its library's thesaurus